Selection2026-10-284 min read

How to check gauge and bowl depth before you approve a sample

Gauge is written in millimetres, not in trade shorthand. Measure three points and write the numbers into the approval sheet.

How to check gauge and bowl depth before you approve a sample

Gauge is the first number buyers ask about and the last one verified. In the trade, a "16 gauge" sink can arrive anywhere between 1.2 mm and 1.5 mm depending on which standard the factory quotes against. That is why a purchase order should carry millimetres instead: 1.0 mm, 1.2 mm, or 1.5 mm, with the tolerance written next to it.

Need this in writing for a tender?

Request a Quote

Measure with a micrometre or a caliper at three places: the centre of the bowl base, the side wall about 30 mm below the rim, and the deck beside the tap hole. Forming stretches the sheet, so the base is normally slightly thinner than the deck. A 0.05 mm difference is normal; a 0.15 mm difference across the same sink is worth a question.

Depth needs the same treatment. Write down whether the figure is from the rim to the drain or from the rim to the lowest point of the base, and specify the drain diameter. Two suppliers quoting "200 mm depth" can be describing bowls that sit 15 mm apart once installed, which matters when the sink has to take a roasting tray.

Put all of it into the sample approval sheet: gauge in millimetres, three measurement points, depth definition, drain size, and the finish reference. When those five lines are signed, a later shipment can be checked against the same document instead of a memory of the first order.

Need this in writing for a tender?

Ask for the specification sheet of any model and we send the table as a document.

Request a Quote